Uvp TB-106 Transilluminator UV Blocking Cover User Manual download pdf

TB-106 Rev STD

Transilluminator UV Blocking Cover Installation

Overview

The purpose of this Technical Bulletin is to explain the process of permanently installing a UVP-

supplied UV blocking cover onto a UVP transilluminator.

To complete this procedure, the following tools and parts will be required:

• Phillips-head screwdriver

• 5/16” nut driver

• 3/8” narrow walled nut driver

• (4) hollow 3/8” nuts (supplied with safety cover)

Caution: This procedure requires a moderate level of technical competence. If you are not

comfortable working with electronics, tools and/or related components, contact UVP for

assistance.

Removal Procedure

When performing the following procedure, place all components (screws, nuts, etc.) in a secure

location, as some will be reused for installation.

1. Turn off the transilluminator by placing the power switch on the front of the unit in the OFF

position. Then, unplug the unit from the wall power.

2. Remove the four Phillips-head screws and washers securing the transilluminator filter frame

to the body of the transilluminator. Lifting up, remove the transilluminator filter frame from the

transilluminator body and place it upside-down on a flat, smooth surface to avoid scratching

the filter glass.

Two of Four

Phillips-Head

Screws and

Washers

Transilluminator

Filter Frame

Transilluminator

Body

1 2 3

TB-106 Rev STD TTeecchhnniiccaall BBuulllleettiinn TTBB--110066 Transilluminator UV Blocking Cover Installation Overview The purpose of this Te

Page 2

3. Locate the two sets of lock nuts and three metal spacers on the inside of the transilluminator filter frame, as shown in the image below. Use the

Installation Procedure 1. With the UV blocking cover hinges facing toward the front of the unit, replace the transilluminator filter frame on top of

No comments

Uvp TB-106 Transilluminator UV Blocking Cover User Manual